How To Replace A Standing Desk Motor?

Replacing a standing desk motor doesn’t have to be difficult—with the right tools and guidance, you can get your new motor up and running in no time. In this article, we’ll show you step-by-step how to replace the motor in a standing desk, from getting the tools you’ll need to testing and securing the new motor. So don your tool belt and let’s get started!

To get started, you’ll need a few common household items, such as a screwdriver, pliers, and an adjustable wrench. 

You’ll also need to be able to access the underside of your standing desk, where the motor is located, in order to gain full access to it. 

If you’re not sure how to do this, check your manual or contact the manufacturer for help.

Disassembling the Desk

Now that you have the tools necessary to replace the motor in your standing desk, it’s time to take it apart. Before you start, make sure you have plenty of space on a flat surface and that all of your tools are nearby and ready. 

Different models of standing desks have different ways to take them apart, but most of them have a similar method. 

Begin by unplugging the desk from any power sources, and then remove any items stored in or on top of the desk. It’s also important to make sure that any tension knobs are loosened before proceeding with disassembly. 

Once everything is out of the way, remove all screws from around the base of your desk with a screwdriver. Carefully lift off the top panels and set them aside. You should now see four screws inside each corner of the steel frame. Remove these screws as well to free up the motor assembly. 

If there are any cables attached to your old motor, carefully unclip them one at a time and store them somewhere safe for future use. 

Once all wires are detached, grab hold of both sides of the old motor assembly and carefully pull it away from its mounting bracket. 

With this step completed, your standing desk motor should now be fully disassembled and ready for the installation of its new motor!

Installing the New Motor

Now that you have all the tools you need and have taken apart your standing desk, you can install the new motor. Depending on the model of your desk, this process may vary slightly but will generally require these few steps: 

First, find the place where the old motor was attached and put the new one there. Make sure to secure any mounting screws or bolts tightly. 

Once you’ve done this, take the power cord that comes with the motor and plug it into your desk’s power supply. This can usually be found near where the old motor was mounted or in your desk’s control panel. 

Next, if you have a multi-motor desk, make sure to connect each wire from the new motor to its corresponding wire coming from another connected motor. This is an important step because it lets your control unit move all of the motors at the same time. 

If you are having trouble locating these wires or figuring out which ones need to be connected together, consult your manual for further instructions. 

Finally, if all wires are connected properly, turn on your control unit and test out your newly installed motor!

Testing and Securing

Once the new motor is installed, it’s time to test and secure it. 

First, connect the power cord of the motor to a power supply and switch it on. Then start adjusting the height adjustment controls on your controller unit, or manually move up and down the desk platform. 

It’s important to check if the speed and range of motion are okay by going through a complete motion cycle. If everything is working as expected, you can now secure the motor in place using the screws or bolts provided with your replacement kit. 

Make sure that all connections are tight before plugging in your desk for use. Finally, test out all functions once more to make sure that everything is working properly.

Conclusion

Replacing a standing desk motor is not a daunting task if you are willing to put in the time and effort. With the right tools, it is possible to disassemble the desk, install the new motor, and then test and secure it properly. Whether you want to upgrade your current motor or replace a broken one, following these steps will help make sure your new motor works well and your desk stays in good shape.